Checking engine oil level, Change engine oil, Change oil filter – Generac Power Systems Air-cooled Recreational Vehicle Generator 9734-3 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Generac NP-66LPG Recreational Vehicle Generator
This section includes information about simple maintenance
which includes the following tasks:
• Checking engine oil level.
• Changing engine oil.
• Changing oil filter.
• Changing the air cleaner.
• Cleaning the air intake screen.
• Cleaning spark plugs.
CHECKING ENGINE OIL LEVEL
Check engine crankcase oil level at least every eight hours of
operation, or before each use (Figure 7).
• Be sure the generator is as level as possible.
• Remove oil dipstick and wipe dry with clean, lint-free cloth.
• Install and tighten oil dipstick, then remove again.
• Oil should be at dipstick FULL mark. If necessary„add the
recommended oil to the FULL mark only. DO NOT FILL
ABOVE “FULL” MARK.
•
Install and tighten oil dipstick cap before operating the
engine.-
NOTE:
See “Engine Oil Requirements" on Page 12 for rec
ommended oiis.
Figure 7 — Oil Dipstick and Fill Tube
CHANGE ENGINE OIL
Change engine oil after the first 25 hours of operation (after
the 25 hour break-in period. Page 8). Thereafter, change oil
every 50 operating hours. Change oil more frequently if oper-
-.ating consistently under heavy load or at high ambient
temperatur^
• Warm up erigine for at-least.five minutes, then shut down.
With engine still warm from running, remove capifrom oil
drain hose (Figure 8). Drain oil completely into a suitable
container.
When oil has drained, install and tighten drain hose cap.
Remove oil dipstick and fill crankcase with the recom
mended oil (See Page 12). The engine crankcase can hold
about 1.4 liters. DO NOT FILL ABOVE “FULL” MARK.
Install and tighten dipstick cap before operating engine.
Figure 8 — Location of Oil Drain Plug
OIL DFIAIN
PLUG
CHANGE OIL FILTER
Replace the engine oil filter after the first 25 hours of opera
tion, every 100 operating hours thereafter.
• Turn oil filter counterclockwise to remove (Figure 9).
• Coatgasketof new filter with engine oil.
• Turn new filter clockwise until its gasket contacts tightly with
the filter adapter. Then tighten with an additional 3/4 to one
turn by hand.
• Run engine.and check for leaks.
NOTE: Check oil level and fill to full mark after checking for
leaks. Filter will retain some oil.
Figure 9 — Engine Oil Filter
TO LOOSEN
Recreational
V e h i c l e G e n e r a t o r
13