Storage, Tiller, Engine – Husqvarna 917.29939 User Manual
Page 16: Other
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

STORAGE
Immediately prepare your tiller for storage at the end of the
season or if the unit will not be used for 30 days or more.
A
WARNING: Never store the tiller with
gasoline In the
tank
Inside
a
building
where fumes may reach an open flame
or spark. Allowthe engineto cool before
storing In any enclosure.
TILLER
•
Clean entiretiller (See “CLEANING” in the Maintenance
section of this manual),
•
Inspect and replace belts, if necessary (See belt re
placement instructions in the Service and Adjustments
section of this manual),
•
Lubricate as shown in the Maintenance section of this
manual,
•
Be sure that all nuts, bolts and screws are securely
fastened. Inspect moving parts for damage, breakage
and wear. Replace if necessary,
•
Touch up all rusted or chipped paint surfaces; sand
lightly before painting.
ENGINE
FUEL SYSTEM
IMPORTANT: ms IMPORTANTTOPREVENTGUM DEPOSITS
FROM FORMING IN ESSENTIAL FUEL SYSTEM PARTS SUCH
AS THE CARBURETOR, FUEL FILTER, FUEL HOSE, OR TANK
DURING STORAGE. ALSO, EXPERIENCE INDICATES THAT
ALCOHOL BLENDED FUELS (CALLED GASOHOL OR USING
ETHANOLOR METHANOL) CAN ATTRACTMOISTUREVyHICH
LEADS TO SEPARATION AND FORMATION OFACIDS DURING
STORAGE. ACIDIC GAS CAN DAMAGE THE FUEL SYSTEM
OF AN ENGINE WHILE IN STORAGE.
•
Drain the fuel tank,
•
Start the engine and let it run until the fuel lines and
carburetor are empty,
•
Never use engine or carburetor cleaner products in the
fuel tank or permanent,
NOTE:
Fuel stablizer is an acceptable alternative in
minimizing the formation of fuel gum deposits during
storage. Add stabilizer to gasoline in fuel tank or storage
container. Always follow the mix ratio found on stablizer
container. Run engine at least 10 minutes after adding
stablizer to allow the stabilizer to reach the carburetor.
Do not drain the gas tank and carburetor if using fuel
stabilizer.
ENGINE OIL
Drain oil (with enginewarm) and replace with clean oil, (See
“ENGINE” in the Maintenance section of this manual).
CYLINDER(S)
•
Remove spark plug,
•
Pour 1 ounce (29 ml) of oil through spark plug hole
into cylinder,
•
Pull starter handle slowly several times to distribute
oil,
•
Replace with new spark plug.
OTHER
•
Do not store gasoline from one season to another,
•
Replace your gasoline can if your can starts to rust.
Rust and/or dirt in your gasoline will cause problems,
•
If possible, store your unit indoors and cover it to give
protection from dust and dirt,
•
Cover your unit with a suitable protective cover that
does not retain moisture. Do not use plastic. Plastic
cannot breathe which allows condensation to form and
will cause your unit to rust,
IMPORTANT: NEVER COVER TILLER WHILE ENGINE AND
EXHAUST AREAS ARE STILL WARM.
16