Service and adjustments, Tiller, Service & adjustments -15 – Husqvarna 917.29939 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SERVICE AND ADJUSTMENTS
A
CAUTION: Disconnect
spark
plug wire from spark plug and place wire where It cannot come Into
contact with plug.
TILLER
TO ADJUST HANDLE HEIGHT (See Fig. 15)
Factory assembly has provided lowest handle height. Select
handle height best suited for yourtilling conditions. Handle
height will be different when tiller digs into soil,
•
If a higher handle height is desired, loosen the four
nuts securing handle panel to engine brackets,
•
Slide handle panel to desired location,
•
Tighten the four nuts securely.
TINE ARRANGEMENT
Yourouter tines can be assembled in several different ways
to suit your tilling or cultivating needs.
A
CAUTION:
Tines
are
sharp. Wear
gloves or other protection when han
dling tines.
NORMAL TILLING - 26 INCH PATH (See Fig. 16)
• Assemble holes
“A”
in tine hubs to holes “B” in tine
shaft.
MID-WIDTH TILLING - 24 INCH PATH (See Fig. 17)
• Assemble holes
“A”
in tine hubs to holes “C” in tine
shaft.
NARROW TILLING/CULTIVATING - 12-3/4 INCH PATH
(See Fig. 18)
• Remove outer tines.
Fig. 18
NOTE:
When reassembling outer tines, be sure right tine
assembly (marked “R”) and left tine assembly (marked “L’)
are mounted to correct side of tine shaft.
13