Step 4: install the battery cables – Troy-Bilt 12204-10HP User Manual

Page 12

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Section 2: Assembly

STEP 4: Install the
Battery Cables

NOTE: The cable terminals should be

toward the rear (keyswitch side) of the

battery posts.

Use a 5/8“ long screw and 1/4-20 hex

nut to connect the positive (+) battery

cable (J, Figure 2-19) to the positive

(marked+) battery post (K). Make sure

that this is the cable on the left side, with
one end attached to the solenoid (Q).

2. Slide the black rubber boot (P) com

pletely over the battery post and cable

connector.

3. Use a 5/8" long screw and 1/4-20 hex
nut to connect the negative (-) battery
cable (L) to the negative (marked -)
battery post (M) and secure with screw
(R) and nut (S).

4. Slide the black rubber boot (T) com

pletely over the battery post and cable

connector.

5. Make sure that the lower end of the
vent tube shield (U) is positioned in front
of the wheel shaft axle. Move it there if

necessary.

Figure 2-19: Battery cable assembly.

Assembiy is complete for electric start
tillers. See Section 3,

Controls ior

information on tiller controls.