Asus P/I-AP55T - Manual (Page 54)

P/I-AP55T User's Manual
PCI and PNP Configuration Setup
This screen configures the PCI Bus slots. All the slots use INTA#.
If you install a card , you should set the card to INTA#.
PCI And PNP Configuration Setup Screen
ROM PCI/ISA BIOS(PI-5XTP4:
PCI AND PNP SETUP
AWARD SOFTWARE INC.
SLOT 1 (Top) IRQ ; Auto
SLOT 2 IRQ r Auto
SLOT 3 (Bottom) IRQ; Auto
PCI Latency Timer : 80 PCI Clock
IRQ 3 Used By ISA No/ICU
IRQ 4 Used By ISA No/ICU
IRQ 5 Used By ISA No/ICU
IRQ 'j Used By ISA No/ICU
IRQ 10 Used By ISA :; No/ICU
IRQ 11 Used By ISA ; No/ICU
IRQ 15 Used By ISA : No/ICU
DMA I Used By ISA : No/ICU
DMA 3 Used By ISA : No/ICU
DMA 5 used By ISA : No/ICU
ISA MEM Block Base : NO/TCU
ESC
FI
F5
F6
F7
Quit T i — S e l e c t Item
Help PU/PD/+/- : Modify
Old Values (SHIFT)F2 ; Color
Load BIOS Defaults
Load Setup Defaults
The first four lines on the screen set how PCI slot IRQ use is de­
termined. The default setting for each line is ''Auto", which will use
auto-routing to determine IRQ use. Use the options "14" or "14&15"
if you install an Enhanced IDE controller card. A card with one chan­
nel should use the "14" setting and a two-channel card should use
the "14&15" setting. Please note that if you use one or both of these
IRQs here, they will not be available to the onboard PCI IDE control­
ler, which uses IRQ 14 for Channel One and IRQ 15 for Channel Two.
You can not share these IRQs betw een two controllers.
3-20