Asus P/I-AP55T - Manual (Page 46)

P/I-AP55T User’s Manual
Chipset Features Setup
This screen controls the settings for the mainboard's chip set. The
controls for this screen are the same as for the previous screen.
Chipset Features Screen
ROM PCI/ISA BIOS(PI-5XTP4)
CHIPSET FEATURES SETUP
AMARD SOFTWARE INC.
Auto Configuration Enabled Onboard IDE Timing Fastest
DRAM Read Timing EDO/STD X222/X333 Onboard FDC Controller Enabled
DRAM Write Timing x222 Onboard FDC Swap A & B No Swap
RAS To CAS Delay 3T Onboard Serial Port 1 C0M1,3F8H
DRAM Leadoff Timing 7T Onboard Serial Port 2 COM2,2F8H
Onboard Parallel Port 378H/IRQ7
PCI Concurrency Enabled Parallel Port Mode Normal
PCI Streaming Enabled SMC ECP DMA Select Disabled
CPU to PCI Burst Enabled
16-bit I/O Recovry Time 3 BUSCLK
8-bit I/O Recovry Time 3 BUSCLK
UART2 Use Infrared : Disabled
Video BIOS Cacheable Disêübled
Memory Hole At 15H-16M Disabled
ESC : Quit Ti-M- : Select Item I
FI : Help PÜ/PD/+/ : Modify 1
F5 : Old Values (SHIFT)F2 : Color 1
F6 : Load BIOS Defaults
F7 ; Load Setup Defaults
The first ten lines after Auto Configuration are optimal settings
for this mainboard that are defined by the Auto Configuration fea­
ture, which configures the settings based on the CPU clock speed. You
should not change them unless you know what you are doing.
You can enable the Memory Hole feature if you need it for an
expansion card you are installing. Refer to the card documentation
for instructions regarding this feature.
3-12