Winding the bobbin – SINGER W1066 User Manual

Page 6

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

3. WINDING THE BOBBIN

1. To wind the bobbin, the balance wheel must be disconnected from the stitching mechanism. Hold the

balance wheel with your left hand and turn the stop motion knob (Fig.

) towards you with your right

hand. This will permit the balance wheel to turn freely while the needle bar remains motionless. The

balance wheel is now disconnected for the bobbin winding operation.

2. Place a spool of thread on the spool pin. Draw thread from the spool through tension guide from back to

front (Fig. 2)

3. Now wind the end of the thread around empty bobbin seven or eight times and place the threaded bobbin

on the spindle of the bobbin winder.

And push the bobbin winder from left to right.

5. Now manipulate your foot control in the same manner as in sewing and when the bobbin is completely

full it will release automatically and stop turning. Detach bobbin from spindle. Hold balance wheel firmly

with left hand and with the right hand turn stop motion knob away from you until if cannot be moved

any further and the needle bar moves with the turning of the balance wheel.