Embroidery and monogramming, Darning – SINGER W1066 User Manual

Page 23

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

24. EMBROIDERY AND MONOGRAMMING

It is quite easy to follow a design or to work free-hand when Embroidering

or Monogramming (see Fig.

). Remove the Presser Foot completely

and turn the Drop-Feed Control to the LEFT to 'DOWN' so that the

Feed-Teeth are fully lowered (see Page 101.

Stretch fabric tightly in an Embroidery hoop and place under the Needle.

Set the Stitch width to the size you prefer or, set at '0' and create your

own widths by movenrtent of the Hoop to suit your pattern. Operate the

Machine rather fast whilst moving the Hoop with both hands. Work care

fully and be sure to keep fingers out of the path of the Needle.

25. DARNING

Remove Presser Foot and lower Drop Feed as for Embroidery above.

Prepare fabric to be mended as above and place under foot. Using a fine

thread and thick Needle, stitch once around hole to incorporate all the

frayed ends.

Next cover hole with vertical lines of Stitching as close together as possible,

covering hole (Fig. 36). Then repeat the operation from side to side until

the hole has again been covered. Once the Machine is in motion, the cloth

must not stand still.

ALWAYS REMEMBER TO RETURN FEED TEETH TO 'UP' POSITION BEFORE RESUMING NORMAL SEtf

- 2 1 -