SINGER W1066 - Manual (Page 18)

18. AUTOMATIC BUTTONHOLES
A) D'TER m :-:^: buttonhole length
Mea , ,re diameter and thickness of button and add 0.3 Cm (1/8")
for "-.jr tacks. Mark buttonhole size on material. (Fig. 23)
.■;i SETTING MACHINE
I, '-- .H the needle to Its highest position by turning the balance
wheel towards you and replace the presser foot in use the
buttonhole 'oot. (Fig. 24) ' .
T Set the zigzag width control to 'O'.
J. Lead thread passes through the slot in the buttonhole foot,
and then to the rear as for normal sewing.
L Completely push back sliding part (a) (Fig. 25) of buttonhole foot.
5. Place material under foot so that marking of buttonhole passes
through center of foot and arrow (b) (Fig. 25) of foot indicates
beginning line of marking.
■
1 6
-