Placing bobbin case in shuttle – SINGER W311 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
* V •
•* f » ■
SLOT
/-■ t- Y
1 - ''
. ‘ \
»■
I \
\
/
■"X
■
Í
L ] V
TENSION SPRING
Fig. 8
N
Fig. 9
Fig. 10
PLACING BOBBIN CASE IN SHUTTLE
Raise needle bar to highest position, and slide cover plate
to the left. (See 17, Fig. l) Hold the bobbin case latch, (D,
Fig. 11) between the thumb and forefinger of the left hand,
with at least three inches of thread running from the top of
the bobbin case to the right. Insert and center the bobbin
case on the stud of the shuttle body, (C). Be sure the
bobbin case finger, (E), is opposite the shuttle race notch (A).
Press the bobbin case (B) info the Shuttle as far as possible
until latch catches on the center post of the shuttle. THEN
release the bobbin case latch, (D). Press bobbin case again
after latch has been released to make sure the bobbin case
is locked securely in place. Close the cover plate.