Binder, Folded binding (fig. 69), Two-tone binding (fig. 70) – SINGER W311 User Manual

Page 37: Hand-cut bias binding (fig. 69)

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

BINDER

This attachment folds bias binding and applies it to the edge of material in one operation.

Slots on scroll of the binder are for corresponding widths of commercially folded bias binding.

The open mouth of binder scroll is used for unfolded bias strips cut inch wide.

FOLDED BINDING

(Fig.

)

Cut a point on folded binding, insert in appropriate

slot. Draw through slot and under binder with strong
pin. Test stitching to be sure it is on the edge. Adjust
by sliding binder to right or left.

V.V

TWO-TONE BINDING

(Fig. 70)

Two bindings can be sewn on fabric edge also in one

operation. When two are used, always skip one size be

tween widths, inserting each in correct size slot.

HAND-CUT BIAS BINDING

(Fig. 69)

Cut

inch bias binding fold in half for a couple

of inches. Cut binding diagonally toward end, almost to

fold. Slip fold into center of binder. Draw back until

cut opens and binding encircles open end of scroll. Test
stitching to be sure it is on the edge, adjust if necessary.

See Figs. 67

and 68 for sug
gestions on

how to use the
binder. There

are hundreds
of other uses.

/ ■

Fig. 69