SINGER W311 User Manual
Page 48
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
47
INSTALLING SEWING HEAD IN PORTABLE CASE
Please read these important instructions which were written to aid you in
placing your new sewing machins in its portable case.
First, remove the foot control which is fastened inside the base to avoid
damage
in
shipping.
After
unpacking
the
sewing
machine
unit,
being
certain
to
take
out
the
Instruction
book,
guarantee
and
accessory
box,
lay the unit face down on a table.
Y o u
will see two clamping screws A
entering head hinge holes
B
on the underside of the back.
On the base you will find two head hinges C which will fit into holes
B .
Lower the base onto the sewing machine fitting hinges C into holes B.
Tighten screws
A
securely with a screw driver.
To make the electrical connection draw the two wires through the slot in the
partition of the base. Plug the cord labeled “Motor” into the receptacle marked
“Motor” on the block attached to the outer section of the base.
Then insert the other cord into the “Light” receptacle.
Place the foot control on the floor, insert plug into a wall outlet (110-115
volts)
and
you
are
ready
to
sew.
But
first
read
the
instruction
book
to
become familiar with the threading of the machine, tension adjustments and
all the other features designed to make sewing a pleasure.
See Fig. 1 01 and 1 02