SINGER W6105 - Manual (Page 7)

REMOVING BOBBIN CASE
K;iise needle to its highest position by
lurning hand wheel toward you. Pull
slide plate out to the left.
I,ill open hinged latch ol bobbin case
and pull case toward the left and out
of machine.
Bobbin will remain in case as long as
atch is open. 1 o remove bobbin, hold
bobbin case down, close latch and
bobbin will fall out.
THREADING BOBBIN CASE
Hold bobbin us shown in illustration
so that thread goes over top of bobbin
and away from you.
Пасе bobbin in case withoul turning
it around.
Slide tliread into slot in edge of case
and draw thread under tension spring.
Pull out thread to check that bobbin
turns clockwise.
INSERTING BOBBIN CASE
Be sure that 5 to 6 inches of thread
extends out of bobbin.
Hold bobbin case so long finger on
case points up. Open out latch.
Slip case over holder post in shuttle
and press in place until finger enters
notch. Release latch.
Close slide plate.
BRINGING UP LOWER THREAD
'1
Raise presser foot. Hold needle thread
loosely with your left hand. Turn hand
wheel toward you until needle moves
down and then up again to its higliest
irosition, catching bobbin thread and
bringing it up through hole in needle
|)late.
^
I d prevent thread from slipping out
of needle when you begin sewing, pull
both thread out about 6” and place
under presser foot toward rear of
machine.