SINGER W6105 - Manual (Page 6)

I tintMUIIMU IVIACHlIMb
WINDING BOBBIN
' —'
I’lace spool ol thread on sp(K)l pin and
pass thread thiougli slots of both top
thread guides.
Bring tliiead down across machine and
under tension discs on Inrbbin winder
thread guide located on corner of
machine base.
Put thread through one of the holes in
empty bobbin from inside to outside.
I’lace bobbin on spindle of bobbin
winder, being sure notch in bobbin fils
over small pin on bobbin spindle.
Push cover of bobbin winder down
until rubber wheel touches hand wheel.
Release sewing mechanism by holding
hand wheel and turning slop motion
knob toward you. Hold end of thread
and press down on foot control as
when sewing. Release end of thread as
soon as winding starts. Run machine
slowly to wind bobbin evenly.
Bobbin winder will stop itself when
bobbin is trill. Do not wind so full that
thread extends beyond bobbin. Break
oil thread and remove bobbin from
spindle.
Tighten slop motion knob.
Winding Bobbin Evenly
It bobbin winds unevenly, adjust
bobbin winder thread guide by loosem
ly screw at base ofguide:
• it more (bread winds on right side
of bobbin move thread guide
slightly to the left.
• il more thread winds on left side
of bobbin iiKwe thread guide
sligliily to the light.
( Ol u\ I
THREADING UPPER THREAD
Raise the needle to its higlrest po
tioii by turning hand wheel toward ;
Till pressei foot.
PI.ice thread on spool pin at back
m.ichine. Pass thread through slots
iwo lop thread guides, then down
illu'ad tension knob.
Place thread around bottom of line
tension knob, being sure it slides f
tween tension discs. Hold thre:
sialionary with right hand and pi
ihiead up with left hand until it sli
around w ire spring and into loop.
I owe I pressei fool.
PI.ice ihiead imder arm of tensii
ihieatl guide, and up through hole
l.ike-up level llnearliiig from riglil
Id I
Bung thread down and place bell in
aim of linead guide located at holloi
ol opening 111 face plate. Draw tinca
down Ihmiigh small thread guide a
ladled to needle hai,
lineari needle from left to right.