Threading the machine, Operating the machine – SINGER 9618 User Manual
Page 23
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Threading the machine
•
Raise the presser foot to release tension
discs and make sure needle and take-up
lever are in highest position.
•
Place spool pin felt from accessories over
spool pin, and place spool of thread on
spool pin with slit A on top.
•
• Keep right hand on spool of thread to hold
firmly in place while threading machine.
• Snap thread into upper thread guide 1.
• Pass thread through point 2.
•
Thread the needle thread tension 3. Slide
thread over metal plate into tension discs.
Lead thread under needle thread tension and
through tension wire by firmly pulling thread
straight up.
•
Pull thread to right behind point 2 guiding
thread up toward take-up lever.
• Pass thread through points 4 to 6 as shown.
• Thread needle from front to back and draw
about 10 cm (4 inches) of thread through eye
of needle.
21