Changing the light bulb – SINGER W710 User Manual

Page 60

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

169

170

a. Use a pure oH, one that has no detergents,

!t is best to buy oil manufactured specifi'

cally for sewing machine use, Other oils
will eventually cause the mechanisms to

lock up.

b. Your machine should be oiled often.

Using a sewing machine oil, piace a single

drop on each oiling point as illustrated,
specifically those points marked in red on

your machine, (Fig. 169, 170) Run the
machine to allow the oil to penetrate.
Your machine cannot be overmlled but
excess

oil

may

drip

and

stain

your

garment.

c. Before oiling the machine remove the

following:

(1) The needle
(2) The presser foot
(31 The needle plate.
After you have finished oiling the machine
replace the bobbin case. The needle plate
should then be placed into its normal
position, followed by the presser foot and

needle.

3. OILING

171

4. CHANGING THE LIGHT BULB

Open the face plate by pulling towards the left.
Turn the light bulb counterclockwise to remove.

Replace the bulb by turning clockwise, (Fig. 171)

A majority of service calls could be avoided by
following the above procedures and by first
checking to see that the machine is:

1. Threaded properly top and bottom.

2. That the bobbin is wound evenly.
3. That the needle is in the machine correctly.
4. Proper cleaning and oiling.

Loose