Preparing to sew to remove the bobbin case – SINGER W671 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
PREPARING TO SEW
To remove the Bobbin Case
BOBBIN CASE FrNGER
SUDE PLATE
Turn the hand wheel toward you until
the needle bar is at its highest point.
Open the slide plate in the bed of the
machine so that bobbin case can be
reached. (Fig. 3)
Insert
the
thumb
and
forefiinger
to
open the latch and withdraw the bobbin
case.
While the latch is held open the bobbin
is retained in the bobbin case and will
not drop out.
(Fig. 3)
On releasing the latch and turning the bobbin case downward, the bobbin will
drop out.
The bobbin case must never be removed when the needle bar is in the lower
position.
■
Neither should a bent needle be used, as it is liable to damage the bobbin case
or the shuttle.
To wind the Bobbin
Disconnect the hand wneel by holding it in the left hand, while turning the stop
motion screw over toward you with the right hand, as shown in Fig. 4.
Wind the free end of the thread several times round the bobbin and press it oniu
the spindie (.4.), passing the thread through the tension bracket (B).
Press the push-button (C) until the latch fits securely into the bobbin. When the