SINGER W671 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Always push the socket back into position before sewing.
The light is turned on and off by means of the switch (B). (Fig. 15)
TO START SEWING
Pull the upper thread through the needle eye and hold it loosely with the left
hand. Turn the hand wheel toward you with the right hand until the needle
moves down and up again to its highest point, thus catching the lower (bobbin)
thread.
Now
pull
the
end
of
the
upper
thread
you
are
holding
and
the
bobbin
thread
will
be
brought
up
with it through the needle hole in
the needle plate, as shown in Fig. 16.
Place both ends of thread back under
the presser foot.
Place the fabric to be sewn beneath
the presser foot, lower the foot upon
it and then start the machine accord-
(Fig. 16)
ing to the directions already given.
Note : For straight sewing, the zigzag width regulating lever (Fig. 1-3) must be
set to the right, so that the zigzag width indicator points to “ O ”.
'
10