SINGER W1665 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
PLACING BOBBIN CASE IN SHUTTLE
Open hinged cover plate in front of the needle. (See 17
Fig. 1). Hold the bobbin case latch, (D), Fig. 10, between
the
thumb
and
forefinger
of
the
left
hand,
with
at
least
three inches of thread running from the top of the bobbin
case
to
the
right.
Insert
and
center
the
bobbin
case
on
the stud of
the
shuttle body, (C). Be sure the bobbin case
finger,
(E),
is
opposite
shuttle
race
notch,
(A).
Press
the
bobbin case into the shuttle as far as possible until latch
catches on the center post of shuttle. THEN release the
bobbin
case
latch,
(D).
Press
bobbin
case
again
after
latch
has
been
released
to
the bobbin case is locked securely in place. Close the cover plate.
Fig. 10
make sure
UPPER THREADING SINGLE NEEDLE
1.
Turn hand wheel toward you to raise take-up lever to highest position.
2.
Place a spool of thread on spool pin A. (Fig. 12)
3.
Lead thread through thread guides Bl and B2 on arm.
4.
Down and around one set of tension discs C from right to left.
5.
Up into check spring D.
6. Down and under thread bar E.