Canon A1100 IS - Manual (Page 111)

Changing Shooting Functions
111
Displaying the Overlay
You can display gridlines for vertical and horizontal guidance, or a 3:2 guide
to confirm the printable area for L size or postcard size prints.
● Select [Disp. Overlay], then press the qr
buttons to select an option.
Changing the IS-Mode Settings
● Select [IS Mode], then press the qr buttons to
select an option.
Grid Lines A grid overlays the display.
3:2 Guide
Gray areas appear at the top and
bottom of the screen. These areas
will not print when printing on 3:2
aspect ratio paper.
Both
Both grid lines, and the 3:2 guide will
display.
• In mode, you cannot set [3:2 Guide] or [Both].
• Grid Lines will not be recorded on the image.
• The gray areas displayed with [3:2 Guide] are the areas that will not be
printed. The actual image recorded will include the portion in the gray
areas.
Continuous
Image stabilization is always on. You
can confirm the result directly on the
display, which makes it easier to
check the composition or focus.
Shoot Only
Image stabilization is only active at
the moment of shooting.
Panning
Image stabilization only counters up
and down motion. This option is
recommended for shooting objects
moving horizontally.
• If camera shake is too strong, attach the camera to a tripod. It is
recommended to set the IS Mode to [Off] when the camera is fixed to a
tripod.
• When using [Panning], hold the camera horizontally. Image stabilization
does not work when the camera is held vertically.