Binder, Folded binding (fig. 34), Two-tone binding (fig. 34) – SINGER W134 User Manual

Page 33: Hand-cut bias binding (fig. 35)

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

BINDER

This attachment folds bias binding, applies it to the

edge of material in one operation. Slots on scroll of
the binder are for corresponding widths of commercial
folded bias binding.

The open mouth of binder scroll is used for un

folded bias strips cut 1 5 / 1 6 inch wide.

FOLDED BINDING (Fig. 34)

Cut a point on folded binding, insert in appropriate

slot. Draw through slot and under binder with strong
pin. Test stitching to be sure it is on the edge. Adjust
by sliding binder to right or left.

TWO-TONE BINDING (Fig. 34)

Two bindings can be sewn on fabric edge also in

one operation. When two are used, always skip one
size between widths, inserting each in correct size slot.

HAND-CUT BIAS BINDING (Fig. 35)

Cut 1 5 / 1 6 inch bias binding fold in half for a

couple of inches. Cut binding diagonally toward end,
almost to fold. Slip fold into center of binder. Draw
back until cut opens and binding encircles open end

of scroll. Test stitching to be sure it is on the edge
adjust if necessary.