Preparing to sew, Removing the work, Removing the work -17 – SINGER W134 User Manual
Page 21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
16
Darning and Mending. In order to move the fabric freely in
any direction for darning, and mending, release the pressure cap
B completely by pressing down on the snap lock, (A, Fig. 20).
Turn the knob to "DN" position, which drops the feed well
below the needle plate. To return feed to normal, return knob
to "HI".
PREPARING TO SEW
Have take-up lever at highest point before starting to sew.
Do not try to help the feeding by pulling the material as this may
p.g_
20
deflect the needle and cause it to break.
NEVER run machine without material under the presser foot.
Place material and threads in position under the presser foot and lower the presser foot.
Turn the hand wheel toward you until the needle is at its highest point. You are now
ready to begin sewing. By having the needle at its highest point, it is not necessary to touch
the hand wheel to start the machine. You merely press the control. The speed of the machine
is regulated by increasing or decreasing the amount of pressure exerted on the control.
REMOVING THE WORK
Be sure to stop the machine when the thread take-up lever and needle bar are at the
highest position. Now raise the presser foot and draw the fabric back and to the left,
fWfVPawpMN