SINGER 626E6 Touch & Sew - Manual (Page 58)

Unlocks Locks
TO CHANGE THE LIGHT BULB
Be sure that Power and Light Switch is in OFF
position.
To remove bulb: With thumb of right hand, push in
and down on tab of light lens and lower the light
bracket. Do not attempt to unscrew the bulb. Press
it up into the socket and at the same time turn bulb
over in direction shown to unlock bulb pin.
To replace bulb: Press new bulb into socket, with
bulb pin entering slot of socket, and turn it over in
direction shown to lock bulb in position. Push entire
assembly up until it snaps in position.
TO REPLACE THE SLIDE PLATE
You will not have any occasion to remove the slide
plate. However, if it should accidentally become dis­
engaged from the machine, it is easily replaced.
® Raise the presser foot and the needle.
® Place slide plate in slide way with the front edge
close to, but not covering, the retaining spring (as
shown).
® With a small screwdriver, lift each end of the spring
into each of the side grooves on the underside of
the plate.
® Draw the plate gently toward you and fully en­
gage the spring.
® Close slide plate.
56