Button sewing foot, Thread shank – SINGER 401A User Manual

Page 68

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

BUTTON SEWING FOOT

Set Red Lever at 4. The needle should then

enter into the right hole of the button. Take
approximately six

zigzag

stitches in this position.

End on the left side.

To fasten stitching, adjust to number one

Red Lever setting and take approximately three
stitches.

THREAD SHANK

In order to form a shank, stitching is done

over a regular machine needle. Position button

and lower button foot. Place needle in the groove
of the foot so the point enters the hole.

A larger shank results when the heavy end of

the needle is utilized.