Using the macro function, Erasing a macro from the macro 1 (or 2) button, Notes – Onkyo TX-SR601 User Manual
Page 74: Erasing a macro from the m acro 1 (or 2) button
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Using the macro function
Erasing a macro from the MACRO 1 (or 2) button
SEND/LEARN
indicator
MACRO 2
MODE buttons
ENTER
1. Press and hold down any one of the seven MODE
buttons, press the MACRO 1 (or 2) button, and then
release both buttons.
When you press the MODE button, it lights and the SEND/
LEARN indicator lights. When you press the MACRO 1 (or 2)
button, the indicator turns off. When you release the buttons, the
indicator flashes once.
2. Press the MACRO 1 (or 2) button again.
The SEND/LEARN indicator slowly flashes twice. The macro
programmed to the MACRO button is erased.
Notes:
• If the SEND/LEARN indicator quickly flashes three times and
turns off, then the remote controller has exited the erasing mode
because either you have made a mistake during era,sing or a
time-out has occurred because no button has been pressed.
Resume from Step 1.
• If you press a button other than MACRO 1 (or 2) button in Step
2, then you will in effect be overwriting the previous macro
with a new macro.
SEND/LEARN
indicator
STANDBY
Erasing ail commands and macros that have
been programmed
ENTER
This procedui'e will erase all the commands and macros that you
have programmed into the remote controller and return it to its
default settings. This operation will not affect the preset settings of
the remote controller.
1. Open the battery cover and remove the batteries from
the remote controller.
2.
While pressing and holding down the ON and
STANDBY buttons, re-insert the batteries in their
correct orientation, and then release both buttons.
The SEND/LEARN indicator flashes slowly.
3. Press the ENTER button.
The SEND/LEARN indicator lights up for about ten seconds
and then turns off.
All programmed commands and macros are era.sed and the remote
controller returns to its factory presets.
Notes:
•
Pi'oceed to Step 3 iniinedialely after Step 2; otherwise, the
batteries will be consumed quickly.
• if you press any button other than the ENTER button in Step 3,
nothing will be era.sed. In this case, resume from Step 1.
74