Onkyo TX-SR601 - Manual (Page 21)

Connections
9. Connecting video camera, etc. (VIDEO 4 INPUT)
Using an RCA video cable, connect Che video output jack
(composite) of the device to the VIDEO 4 VIDEO jack of the TX-
SR701/701E/601/60ÍE. Or if the device has an S video output Jack,
connect it to the VIDEO 4 S VIDEO jack of Che TX-SR70Ì/701E/
601/601E using an S video cable.
Using an RCA audio cable, connect the audio output jack of Che
device to the VIDEO 4 AUDIO jacks of the TX-SR70Í/701E/601/
601E. Make sure that you properly connect the left channel to the L
jack and the right channel to the R jack.
If the device has an optical digital output, connect it to the VIDEO 4
DIGITAL jack of the TX-SR701 /701E/601 /601E.
The VIDEO 4 digital input is fixed to the OPTICAL input on
the front panel.
S Video output
PRE OUT (TX-SR701/701E only)
These jacks are for connecting an auxiliary power anipliher.
You can use an auxiliary power amplifiers to listen at louder
volumes than you can with the TX-SR701/701E alone. When using
a power anipliher, connect each speaker to the power amplifier.
0 0 ©>
12V TRIGGER ZONE 2 terminal
When the TX-SR70l/70]E/601/60iE is in the ZONE 2 mode, this
terminal outputs at 12 V/100 mA.
1
.
2 .
3.
4.
Front right speaker 5.
Front left speaker 6.
Surround right 7.
speaker
Surround left speaker 8.
Subwoofer
Center speaker
Surround back right
speaker
Surround back left speaker
Note:
If you use a power amplifier connected to the SURR BACK PRE
OUT terminal and connect two surround back speakers to the
amplifier, set the “Hardware Conlig” —> “b. Surr Back” setting to
“2ch (PRE OUT)” (see page 35).
21