Onkyo TX-SR601 - Manual (Page 43)

Selecting an Audio Component
Temporarily changing the speaker output levels
To change the individual speaker volumes temporarily, follow the
procedure given below. Each channel can be set between -12 and
+12 decibels. For subwoofer, values between -15 and +12 decibels
can be set. Note that the calibration settings will return to the
original settings when the TX-SR701/701E/601/601E is put in
standby.
Using the remote controller;
1. Press the RCVR MODE button.
2. Press the CH SEL button and select
the desired speaker.
Press the LEVEL A or ▼ button to
adjust the volume level.
Notes:
You cannot select a speaker if the configuration value of the
speaker is set to “No” or “None.”
If the speaker level is set to +1 dB or higher, the maximum level
indicated on the display will change if you raise the volume
level.
When you press the TEST button after you set the level, the
current level will be used as the value set via the test tone.
To change the display of the input source from
TAPE to MD
If you connected an MD recoider to the TAPE jacks of the TX-
SR701/701E/601/601E, you can have “MD” appear when the TAPE
soui'ce button is pressed. By changing the display, when an Onkyo
MD recorder is R¡-connected, the R| system functions will
become enabled.
Changing the display:
Press and hold down the TAPE source button until the display
changes from TAPE to MD (approx. 3 seconds).
TAPE
To return the display to its original setting, perform the same
procedure. This setting is necessary to allow R| system functions
for a connected Onkyo cassette tape or MD recorder.
43