Onkyo TX-SR601 - Manual (Page 7)

Supplied acœssories
Check thaï the following accessories are supplied with the TX-SR701/701E/
601/601E.
AM loop antenna x 1 FM Indoor antenna x 1
Remote controller x 1
TX-SR701/701E: RC-533M
TX-SR601/601E: RC-515M
Batteries (AA, R6) x 2
Speaker cable label x 1
The following accessories may be available depending
on the area which it was purchased.
Conversion plug X 1
(Use this plug if the power cord plug of the TX-
SR701/701E/601/601E does not ht your AC outlet.
Shape may vary depending on the area which it was
purcha.sed.)
75/300antenna adapter x 1
Before using this unit
Setting the voltage selector
(Worldwide models only)
Worldwide models are equipped with a voltage selector so that you
can set your TX-SR701/701E/601/601E to conform with local
power supplies. Be sure to set this switch to match the voltage of the
power supply in your area before plugging in the unit.
Determine the proper voltage for your area: 220-230 V oi' 120 V. if
the preset voltage is not correct for your area, insert a screwdriver
into the groove in the switch and slide the switch all the way to the
top (120 V) or bottom (220-230 V), whichever is appropriate.
Installing the remote controller batteries
1. Remove the battery compartment cover by pressing it
and sliding it in the direction shown by the arrow below.
2. Insert two AA (R6) batteries into the battery
compartment. Carefully follow the polarity diagram
(positive (+} and negative (-) symbols) inside the
battery compartment.
3. After the batteries are installed and seated correctly,
replace the compartment cover.
Notes:
• Do not mix new batteries with old batteries or different kinds of
batteries.
• To avoid coiTosion, remove the batteries if the remote controller
will not be used for a long time.
• Remove dead batteries immediately to avoid damage from conosion.
If the remote controller does not operate smoothly, lemove the old
batteries and replace them both with two new AA batteries.
Using the remote controller
Point the remote controller toward the remote control sensor. The
STANDBY indicator lights up when the unit receives a signal from
the remote controller.
Remote control sensor TX-SR701 /701E/601 /601E
Notes:
• Make sure that the remote control sensor is not subject to strong
light such as direct sunlight or inverted fluorescent light for it
may prevent proper operation of the remote controller.
• Using another remote controller in the same room or using the
TX-SR701/701 E/601/60IE near equipment that uses infrared
rays may cause operational interference.
• Do not put objects on the remote controller. Its buttons may be
pressed by mistake and drain the batteries.
• Make sure the audio rack doors do not have colored gla.ss.
Placing the TX-SR701/701 E/601/60IE behind such doors may
prevent proper remote controller operation.
• If there is any obstacle between the remote controller and the
remote control sensor, the remote controller will not operate.
7