Onkyo TX-SV535 - Manual (Page 20)

Using the tuner
Please make sure that the TAPE-2 MONITOR indicator is off and audio muting is otf.
1
FM MUTE/MODE 1,
Tuning the radio (Manuai tuning and Direct tuning!
■■/ When the frequency is not known-Manual tuning
,1. Press the FM or AM button.
; 2. Use the ◄ DOWN TUNING UP ► buttons to change the fre­
quency.
UP............the frequency increases.
DOWN ....the frequency decreases.
• The frequency is changed in 50 kHz steps in FM and 10 kHz (or
7 /,■•;■ 9kHz) in AM when the tuning selector button is pressed in single
”. ... steps.
• If this button is held continuously for more than 0.5 seconds, the
frequencies are scanned automatically. (FM auto tuning mode)
When a broadcast is receir ed, scanning stops.
MNC_____ POR
When the frequency is known-Direct tuning
. Press the FM or AM button.
. Press the DIRECT TUNING button.
The ■■--" will Hash 16 seconds in the frequency display.
,. Enter the frequency with the number buttons while the cursor
are flashing.
Example: 88.10 MHz 8^8^ I ^0/10
• When receiving AM broadcasts with a 9 kHz step (this depending
on your region), you can enter the frequency directly.
• With 10 kHz steps, entering a number for the K) kHz digit will set
the I kHz digit autotnatically to 0.
• If you enter a frequency that does not have a station, this unit will
automatically tune to the next station immediately below that sta­
tion.
• If you enter a frequency that is out of range, this unit w ill return to
the previous frequency. If this happens, repeat the procedure.
FM MLTC MODE
:n FM MUTE OFF
Listening to a stereo radio stations (FM oniy)
If you tune in a stereo FM station, the STEREO indicator w ill be illu-
If the signal is weak, it may be impossible to tune in to your desired
station. In this case, tunc in as follows.
Press the FM MUTE/MODE button and FM MUTE OFF lights. At
this time, the station will be in mono and interstation noise will be
heard. Select the station vou want listen to.
20