Onkyo TX-SV535 - Manual (Page 12)

Antenna connections
The antenna adaptor is only included with worldwide models.
Indoor
T-shaped
Antenna
Connecting the T-shaped
antenna or
300 ohm ribbon wire
to the 75/300 ohm adaptor
(Worldwide models)
Loosen the screws and wrap the wire around
these screws. Then tighten the screws with a
screwdriver
Connecting the coaxial cable
to the 75^00 ohm adaptor
(Worldwide models)
1. With your fingernail or a small screw­
driver. press the stoppers outwards and
remove the cover.
2. Remove the transformer wire A from slit
B and insert it into slit C.
3. Prepare the coaxial cable as shown in the
diagram. Connect the 7.3/300 ohm antenna
adaptor to the coaxial cable
1 Insert the end of the cable.
2 Clamp it in place with pliers.
To receiver To TV (or VCR)
Directional Itnicsge
Do not use the same antenna for both LM and
TV (or VCR) reception since the FM and TV
(or VCR) signals can interfere with each
other. If you must use a common FM/TV (or
VCRl antenna, use a directional linkage type
splitter.
Assembling the AM loop
antenna
Assemble the loop antenna as shown in the
illustration.
Z-
\ /
y
Connecting the antenna cable
1. Press down the lever.
2. Insert wire.
3. Return the lever.
12