Sears OVERLOCK 3/4D 385.16631 User Manual

Page 22

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

SECTION : 2. : :PREPARE.YOUR MACHINE-FOR SEWING

@ Insert the thread between tension discs from

the right. Then pull both sides of thread.

(J) Turn the hand wheel toward you to bring

needle bar to its highest position, then pass the

thread through thread take-up lever thread

guide.

@ Pass the thread through needle thread guide

sliding the thread from right to left.

@ Pass through needle bar thread guide from left

to right.

Q) Thread the left needle from the front to the

back and pull the thread about 10 cm (4")
from the eye of the needle to the back under

the foot.

— Gently pull all four thread ends towards back of

machine.

— Replace presser foot (See page 27).
— Run threads under presser foot.

— Return knife to up position (See page 29).
— Close side and looper covers.

— Turn hand wheel toward you to chain off three

or four stitches.

NOTE: Needle may be easier to thread if you

remove presser foot (See page 27) and

lower the knife (See page 29).