Sears 113.23611 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
3. When the space between the square and the blade is
minimal tighten the bevel lock knob.
The table should now be approximately 90 degrees to the
blade.
4. Loosen the screw holding the bevei scale pointer and adjust
pointer to 0 degrees. Tighten screw.
Remember, the be^l scale is a convenient guide but should
not be relied upon for precision.
^
Make practice cuts in scrap wood to determine if your angle
settings are correct. Adjust the table as required,
NOTE:
AVOID SETTING THE EDGE OF THE TABLE AGAINST
TOP OF MOTOR WHICH COULD CAUSE NOISE WHEN THE
SAW IS USED.