Sears 113.23611 - Manual (Page 5)

unpacking and checking contents
TOOLS NEEDED
I COMBINATION SQUARE
MEDIUM PHILLIPS SCREWDRIVER
COMBINATION SQUARE MUST BE TRUE
DRAW LIGHT
LINE ON BOARD
ALONG THIS EDGE
STRAIGHT EDGE OF
___ BOARD 3M" THICK
y THIS EDGE MUST BE
PERFECTLY STRAIGHT
SHOULD BE NO GAP OR OVERLAP MERE WHEN
SQUARE IS FLIPPED OVER IN DOTTED POSITION
WARNING: FOR YOUR OWN SAFETY, NEVER CONNECT
PLUG
TO POWER SOURCE OUTLET UNTIL ALL
ASSEiWBLY STEPS ARE COMPLETE, AND YOU HAVE
READ AND UNDERSTAND THE SAFETY AND OPERA­
TIONAL INSTRUCTIONS.
CAUTION: NEVER LIFT THIS SAW BY THE ARM WHICH
HOLDS THE BLADE OR DAMAGE WILL OCCUR TO YOUR
SAW.
Separate all parts from packaging materials and check each
item with illustration and "Table of Loose Parts”. Make certain
all items are accounted for before discarding any packaging
material.
If any parts are imissing, do not attempt to assemble the Scroll
Saw. plug in the power cord, or turn the switch on until the
missing parts are obtained and installed correctly.
Table of Loose Parts Qty,
1 . 16" Scroll Saw........................................................................ 1
2 . Blade Guard........................................................................... i
3. Owner’s Manual.......................................................................i
4. Loose Parts Bag (containing)
Blade ...................................................................................... -j
Re-Oil Caps............................................................................. 4
Switch Key.............................................................................. 1
NOTE: Hardware to mount this scroll saw to a bench or leg set
NOT supplied. See mounting instructions for recommended
hardware size.