Sears 113.23611 - Manual (Page 11)

mounting the scroll saw to a bench
4. Example of mounting this scroll saw to workbench. 1. When mounting this saw to a workbench a solid wood
bench is preferred over a plywood bench where noise and
vibration will be more noticeable.
2. Hardware to mount this saw to a workbench is NOT
supplied with the saw. However, we recommend the hard­
ware used be no smaller than the following.
Quantity Description
4 Hex Head Screws, '^-20 x Length Required
4 Flat Washers, %2 i.D.
4 Lockwashers, %2 I.D.
8 Hex Nuts, ■'^-20
3. A soft foam pad to place between your scroll saw and work­
bench is NOT supplied with the saw. However, we highly
recommend the use of such a pad to reduce noise and
vibration.
Quantity Description
1 Soft foam pad such as carpet padding,
24" X 12" X Yz"
Do NOT overtighten mounting bolts—leave some cushion in
the foam pad for absorbing noise and vibration.
4. if you prefer to mount your saw to a leg set we recommend
the leg set for bench top tools which is available through
Sears Retail or Catalog Stores. The number of this leg set
is 9-22244. This leg set is an optional accessory and
instructions to mount the scroll saw to this leg set are
included in the leg set package.
11