Sears 113.23611 - Manual (Page 15)

MOUNTING AN AUXILLIARY WORK TABLE
1, Four holes are provided in the work table so can easily
attach an auxiiliary work surface to the saw if your needs
require.
2. Mounting an auxiiliary table can allow you to build a larger
support area to suit your project, and could render a
smoother work surface, as your needs require and an
auxiiliary surface can give you more support close to the
blade for special cutting needs like very small or detailed
projects.
EXAMPLE OF MOUNTING AN AUXILLIARY WORK SURFACE TO THE SAW TABLE
a M 4 HEX NUTS
WARNING: TO AVOID TOOL TIPPING OR SUPPORT
FAILURE, AUXILLIARY WORK SURFACE SHOULD NOT
EXCEED 24"
X 12" x Vi"
At least an '/4 inch hole will be needed in the auxiiliary surface
to insert blades.
DRILL the hole for the blade first. Then MARK location of other
holes.
HARDWARE—not supplied—recommended to mount
auxiiliary surface to saw worktable.
Quantity Description
4 Flat Head Screws #8-32 x 1
4 Fiat Washers #8
4 Lockwashers #8
4 Hex Nuts #8-32
15