Head, Motor – Sears 113.24611 User Manual

Page 9

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

9. Gently push down on the FEED HANDLES until the

head raises upwards as far as it will go.

DO NOT RELEASE FEED HANDLE.

10. TIGHTEN THE HEAD LOCK HANDLE AND THE

QUILL LOCK HANDLE.

11. HOLD onto the Feed Handle and UNLOCK the quill

lock handle.

12. Let the quill return to the UP position in the head.

13. TIGHTEN THE QUILL LOCK HANDLE.

Repeat steps 3 thru 10 until the head is raised to the

desired position. Position HEAD SUPPORT COLLAR
underneath the head and tighten the bolts.

CAUTION: Do not raise the

head

above the top of the

column.

HEAD EVEN

WITH TOP

OF COLUMN

<^~~H£AD SUPPORT

COLLAR

INSTALLING

MOTOR PULLEY

When using a double shaft motor, remove the KEY from
the 5/8 in. dia, shaft.

Using a 5/32 in. setscrew wrench, UNSCREW the

setscrew in the pulley so that it is clear of the

KEYWAY (GROOVE).

Place the pulley on the shaft. Make sure it slips on

EASILY ., . don't FORCE it. Remove any burrs in the
pulley or on the shaft if any.

3. Position the pulley so that the KEYWAYS in the shaft

and in the pulley line up; and the small end of the
pulley is about 1/16 of an inch away from the

motor.