Sears 300 - Manual (Page 4)

ASSEMBLY
Assembly requires two people. Due to the size
and weight of the SYSTEM 300, assemble it in the
location where it will be used.
Place all parts of the SYSTEM 300 in a cleared area
and remove the packing materials; do not dispose of
the packing materials until assembly is completed.
Before beginning, read each assembly step and look
at each drawing carefully. As you assemble the
SYSTEM 300, make sure that all parts are oriented
exactly as shown in the drawings. Tighten all parts
as you attach them, unless instructed to do otner-
wise. For help identifying small parts, refer to the
PART IDENTIFICATION CHART attached to the
center of this owner's manual.
THE FOLLOWING TOOLS (NOT INCLUDED) ARE
REQUIRED FOR ASSEMBLY: Two adjustable
wrenches, a phillips screwdriver, a flat screwdriv­
er and a rubber maiiet. Lubricant, such as grease
or petroieum jelly, and a small amount of soapy
water are also required.
To simplify assembly, the following tools are recom-
menoed: A socket set, open or closea wrenches, or
ratchet wrenches.
1. Tap a 2” Outer Cap (15) onto the Base (43).
Tap two 2” Outer Caps (15) onto the Stabilizer
(69). Tap a 2” x 2” Inner Cap (78) into the
Stabilizer.
Attach the Stabilizer (69) to the Base (43) with
two 3/8”
X 2 1/2” Bolts (3), two 3/8” Washers (4),
and two 3/8” Jam Nuts (2).
Do not fully tighten the Jam Nuts yet.
2. Insert SIX 3/8 " X 2 3/4” Carriage Bolts (1) up
through the holes in the Stabilizer (69) and the
Base (43).
Attach the VKR Upright (70) to the two indicated
3/8”
X 2 3/4” Carriage Bolts (1) in the Stabilizer
(69) with two 3/8” Jam Nuts (2).
Do not fully tighten the Jam Nuts yet.