Sears 300 - Manual (Page 14)

32. Attach a VKR Arm Pad (75) to the Left VKR Arm
(73) with two 1/4” X 2 1/2” Screws (41) and two
1/4” Flat Washers (40).
Attach a VKR Arm Pad (75) to the Right VKR Arm
(74) in the same manner.
33. Attach the VKR Backrest (76) to the VKR Upright
(70) with two 1/4” X 2 1/2” Bolts (94) and two 1/4”
Flat Washers (40).
34. Attach a Backrest (39) to the Squat Upright (71)
with two 1/4” X 2 1/2” Bolts (94) and two 1/4” Flat
Washers (40).
35. Tap a 1 3/4” x 1 3/4” Inner Cap (24) into the
Squat Seat Frame (11).
Insert a 1/4” X 2 1/4” Carriage Bolt (66) into the
center hole of each Seat Bracket (67).
Attach each Seat Bracket (67) to the Squat Seat
(65) with two 1/4” X 1/2” Screws (37).
Attach the Squat Seat (65) to the Squat Seat
Frame (11) with the two 1/4” x 2 1/4” Carriage
Bolts (66), two 1/4” Flat Washers (40), and two
1/4” Nylon Locknuts (68). Make sure that the
wide end of the Squat Seat is turned as
shown.
14