Sears 300 - Manual (Page 15)

36. Tap a 1 3/4” x 1 3/4” Inner Cap (24) into the Leg
Lever (62).
Attach the Leg Lever (62) to the Squat Seat
Frame (11) with a 3/8” x 2 1/2” Bolt (3) and a 3/8”
Jam Nut (2).
Insert the 3/8” x 4” Eyebolt (55) through the Leg
Lever (62) from the indicated side. Attach the
Eyebolt with a 3/8” Flat Washer (4) and a 3/8”
Jam Nut (2).
r. Align ilio i'i...:oo in tha C ^uai. Seat Fra .'.o (11) with
one of the brackets on the Squat Upright (71).
Attach the Squat Seat Frame with a 5/16” x 2 3/4”
Carriage Bolt (59) and a 5/16” Knob (61). The
Squat Seat can be attached at any of three
heights.
38. Tap 3/4” Round Caps (50) into the ends of both
Pad Tubes (58).
Insert the Pad Tubes (58) into the holes in the
Leg Lever (62) and the Squat Seat Frame (11).
Slide two 6 1/2” Foam Pads (57) onto each Pad
Tube (58).
39. Attach the Press Seat (35) to the Press Seat
Frame (36) with four 1/4” x 1/2” Screws (37).