beautypg.com

To transport, Towing carts and other attachments, Before starting the engine – Sears 917.275223 User Manual

Page 18: Check engine oil level, Add gasoline, To start engine

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

2

.

TO TRANSPORT
When pushing or towing your tractor, be
sure to disengage transmission by

piacing freewheel controi in freewheeling
position. Free wheei controi is located at
the rear drawbar of tractor.

1. Raise attachment lift to highest

position with attachment lift control.

Pull freewheel control out and into the

slot and release so it is held in the
disengaged position.

* Do not push or tow tractor at more than

two (2) MPH.

• To reengage transmission, reverse

above procedure.

NOTE: To protect hood from damage

when transporting your tractor on a truck
or a trailer, be sure hood is closed and

secured to tractor. Use an appropriate
means of t^ng hood to tractor (rope, cord,
etc.).

TOWING CARTS AND OTHER ATTACH­
MENTS
Tow only the attachments that are
recommended by and comply with
specifications of the manufacturer of your
tractor. Use common sense when towing.
Too heavy of a load, while on a slope, is
dangerous. Tires can lose traction with
the ground and cause you to lose control
of your tractor.

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL
The engine in your tractor has been
shipped, from the factory, already filled
with summer weight oil.

1. Check engine oil with tractor on level

ground.

2. Unthread and remove oil fill cap/

dipstick; wipe oil off. Reinsert the
dipstick into the tube and rest oil fill
cap on the tube. Do not thread the
cap onto the tube. Remove and read
oil level. If necessary, add oil until
“FULL” mark on dipstick is reached.

Do not overfill.

• For cold weather operation you should

change oil for easier starting (See “OIL
VISCOSITY

CHARr

in the Mainte­

nance sectbn of this manual).

• To change engine oil, see the Mainte­

nance sectbn in this manual.

ADD GASOLINE
• Fill fuel tank. Use fresh, clean, regular

unleaded gasoline with a minimum of
87 octane. (Use of leaded gasoline
will increase carbon and lead oxide
deposits and reduce valve life). Do not
mix oil with gasoline. Purchase fuel in
quantifies that can be used within 30
days to assure fuel freshness.

IMPORTANT: When operating in
temperatures below 32°F(0'’C), use fresh,
clean winter grade gasoline to help

insure good cold weather starting.
AWARNING: Experience indicates that
alcohol blended fuels (called gasohol or
using ethanol or methanol) can attract
moisture which leads to separation and

formation of acids during storage. Acidic

gas can damage №e fuel system of an
engine while in storage. To avoid engine
problems, the fuel system should be
emptied before storage of 30 days or
longer. Drain the gas tank, start the
engine and let it run until the fuel lines
and carburetor are empty. Use fresh fuel

next season. See Storage Instructions for
additional information. Never use engine
or carburetor cleaner products in the ^el
tank or permanent damage may occur.
ACAUTION: Fill to bottom of gas tank
filler neck. Do not overfill. Wipe off any
spilled oil or fuel. Do not store, spill or
use gasoline near an open flame.

TO START ENGINE

When starting Ihe engine for the first time or if
the engine run out of fuel, it wil take extra
cranking time to move fuel from the tank to

the engne,

1. Be sure freewheel control is in the

transmission engaged position.

Sit on seat in operating position,
depress brake pedal and set parking
brake.

Move attachment clutch to “DISEN­

GAGED" position.

Move throttle control to fast position
Pull choke control out for a cold

engine start attempt. For a warm
engine start attempt the choke control

may not be needed.

2

.

18