Sears 580.32601 - Manual (Page 3)

TABLE OF CONTENTS
WARRANTY
RULES FOR SAFE OPERATION
SPECIFICATIONS....................
NOMENCLATURE ...... ............
WIRING DIAGRAM ............... .
INSTALLATION OF STAND-BY
POWER SYSTEMS..........
REPAIR PARTS ......... ...........
Section 1 — Preparation For Use
Alternator Unpacking and Remova
From Shipping Skid.................
Parts Shipped With Alternator „ , . .
Wheel Kit Installation .................. ..
Lubrication......................................
Battery Installation..............
Battery Connections ......................
Fill Fuel Tank,,...,............................
Install Fuel Tank ...........................
Cord Sets for 120 Volt, 15 Amp OutI
Optional Wiring Connections - 240
Connector Plug........................
Optional Wiring Connections -120
30 Amp Connector Plug ....... „
Grounding The Alternator ...............
Inside Front Cover Section 2 — Operating Instructions
inside Front Cover
ets...
Volt
Volt,
, 2
,3
........4
, 25-28
.,5
,.5
.7
. 8
,.9
,.9
10
10
10
11
11
12
Do and Don’t Chart...... .......................
Before Starting the Engine.......... ........
Starting the Engine......................... .....
Stopping the Engine............. ...............
Wattage and Power......... ...... .............
Using the 120 Volt, 15 Amp Outlets ..
Using the 120 Volt, 30 Amp Outlet___
Using the 240 Volt, 20 Amp Outlet___
Don’t Overload the Alternator.............
Motor Starting Requirements...............
Charging a Battery............................. .
Section 3 — Preventive Maintenance
Maintenance Chart........ .....................
General Inspection ............................ .
Change Oil .........................................
Service Air Cleaner.............................
Inspect 30 Amp Fuse.........................
Spark Plugs..........................................
Clean Fuel Tank...................................
Inspect Cooling Fins............................
De-Carbonize Muffler............. .
Replace Fuel Filter..............................
De-Carbonize Engine Cylinder Heads .
Storage ...............................................
13
14
15
16
16
16
16
17
17
17
18
,19
19
,20
21
,21
22
22
,22
23
,23
. 23
,23
SPECIFICATiONS
Model No. 580.326010
Wattage Capacity 4500 Watts Continuous (5600 watts momentary surge)
Voltage Output 120/240 Volts
K
o
Amperes (Maximum) 37,5 at 120 Volts -18.75 at 240 Volts
<
Frequency 60 Hertz at 1800 rpm
cc
Phase(s) Single Phase
111
H
Driven Speed 1800 rpm
<
Voltage Regulation
Solid state "Voltage over Frequency” regulator maintains
2120 vofts (± 2%) at 60 Hz.
Electrical Outlets
(2^ 120 Volt, 15 Amp
(1)-120 Volt. 30 Amp
(1)-240 Volt, 20 Amp
Make and Model Briggs & Stratton Model No. 401415
Horsepower Approximately 1Ö H.P. at 1800 rpm
No. of Cylinders 2
Displacement 40 Cubic Inches (656 cc’s)
Ui Governed Speed 1800 rpm
o
Fuel Tank Capacity 5 Gallons (18.925 Liters)
111
Recommended Fuel
Use clean, fresh NON-LEADED gasoline (Leaded, REGULAR grade
gasoline is an acceptable substitute)
Crankcase Oil
Capacity
3V2 Pints (1.65 Liters)
Spark Plug
Use Champion J*8, Auto-Lite A-71, or AC GC46
Set gap to ,,030 inch
Starting Electric Ring Gear
Cooling System Forced air (Centrifugal Blower Type)
Air Cleaner Dry paper cartridge with oil foam pre-cleaner