Sears FTK-130 - Manual

FTK-127/130 Built-In Trim Kit Installation Instructions
For use with the following microwave oven ACW12160A and UIVIC5200AA
Proper installation is the installer's responsibility!
Write the model & serial numbers on the owner's manual.
The mode! number label is located on the oven front.
UL Listed-For use over electric heat source
models
(Wall Ovens)
• 27": AOES2730. AOCS2740,
MEW5527DD. MEW6527DD
‘ 30": AOES3030, AOCS3040,
MEW5530DD. MEW6530DD.
AEW3530DD, AEW4530DD,
JJW8130DD, JJW9130DD
^ WARNING
To avoid risk of electrical shock, personal injury, or
death, disconnect power to wall outlet before beginning
installation.
Parts, Tools, and Materials
The following parts are supplied with the oven:
Tools required to perform installation:
• Phillips Screwdriver
• Saw (Electric or Hand)
• Drill with Vi6" and T 64 " drill bits (Electric or Hand)
• Tape Measure
• Pencil
• Framing Square
• Level
Shipping Weight
• Approximate shipping weight is 16 tbs.
Cutout Dimensions
Dimensions 27" 30"
Height 16 3/4" 16 3/4"
Width 25 1/2" 25 1/2"
Depth (min.) 23 3/4" 23 3/4"
3" min.
Electric Heat Source Model
Î
Height
1
A WARNING
To avoid risk of electrical shock, persona! injury, or
death:
• Before drilling into the wail, note where electrical
outlets are and where electrical wire might be
concealed behind the wall. YOU COULD GET AN
ELECTRICAL SHOCK if you contact electrical wire
with the drill bit.
• Locate and disconnect the power to any electrical
circuits that could be affected by installing this oven.
IF YOU DO NOT DISCONNECT THE POWER, YOU
COULD GET AN ELECTRICAL SHOCK.
A CAUTION
To avoid personal injury, wear gloves when handling the
metal parts. Parts are sharp and can cause cuts and
abrasions.