De-carbonize muffler, Replace fuel filter, De-carbonize engine cylinder heads – Sears 580.32601 User Manual
Page 25: Storage
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
DE-CARBONIZE MUFFLER
Clean carbon and condensation from spark
arrest muffler every 100 hours of operation.
Remove pipe plug from muffler. Start engine
and let run for about 5 - 10 minutes. Shut
engine
down.
When
muffler
has
cooled,
reinstall pipe plug.
REPLACE FUEL FILTER
Replace In-Line Fuel Filter every 300 hours of
operation, or when obviously clogged. Use
pliers to spread clamps each end of fitter
then slide clamps free of filter ends. Install
new filter with arrow on filter body pointing
away from fuel tank. Retain hose to filter with
hose clamps. Start engine and check for
leaks.
Replace
defective
hoses
or
hose
clamps.
Spark Arrest
Muffler
DE-CARBONIZE ENGINE CYLINDER HEADS
Excessive carbon buiid-up in engine combustion area will rob engine power and result in rough
engine operation. Have carbon deposits removed every 300 operating hours, more often if
operating under a steady load, or whenever cylinder head is removed.
STORAGE
Whenever the alternator is to be idle for longer than 30 days, prepare for storage as follows;
1, Disconnect fuel supply hose from fuel tank filler cap,
2. Start engine and let it run out of gas.
3, Let engine cool.
4, When engine has cooled, remove both spark plugs. Pour 2 or 3 tablespoons of clean engine oil
into each spark plug opening. Crank engine to distribute oil.
5. Store unit in a clean, dry, dust-free area.
6. Before using unit after storage, drain and refill engine crankcase with recommended oil. See
CHANGE OIL, Page 20.
23