Assembly, Installing motor, pulley, v-belt, and belt guards – Sears 113.243311 User Manual

Page 8

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

assembly

MOUNTING BAND SAW/SANDER ON LEG SET

NOTE: For illustrative purposes, the Band Saw is shown
mounted on the Craftsman Catalog No. 9-22236 Steel *Leg
Set. This Leg Set is included with Model No. 113.243311.

T. Remove the Band Saw cover by applying gentle side

pressure on the spring tabs and release the top portion
of the cover by pulling it away from the frame. Repeat
procedure for bottom portion of cover.

NOTE: Check the bolts which hold the feet to the Band

Saw as shown. Make sure they are tight.

CHECK BOLTS

FOR

TIGHTNESS

RIGHT

FOOT

2. Place the Band Saw on the Steel Legs, position as

shown and align the mounting holes in the feet of the
Band Saw with those in the END STIFFENERS ¡marked
with an X in the illustration).

3. Mount saw to legs using four (4) 5/16-18X1" hex head

screws, iockwashers. and hex nuts. Tighten screws.

INSTALLING MOTOR, PULLEY, V-BELT,

AND BELT GUARDS

1. Locate the following parts;

Qty. Description

Motor

"L" Bracket

1 Small Pulley (approx. 2-1/2" Dia.)

1 Large Pulley (approx. 5" Dia,}

1 Woodruff Key 3/16"

V-8elt 1/2 X 52

Motor Cord Clamp

4 Carriage Bolt 5/1B-18 X 3/4
4

Flat Washer 5/16

I.D.

Lockwasher 5/16

I.D.

Hex Nut 5/16-18

Guard Assembly including a guard support, guard
support bracket, self-threading screws, and clips.

2. Fasten a belt guard support to the band sawframewith

self-threading screws.

3. Install clips onto the guard support with long end facing

you.

This manual is related to the following products:

113.2433