Sears 113.243311 - Manual (Page 29)

CRAFTSMAN 12-INCH BAND SAW/SANDER. MODEL 113.243300 & 113.243311
NOTE;
ANY ATTEMPT TO REPAIR THIS MOTOR
MAY CREATE A HAZARD UNLESS
REPAIR IS DONE BY QUALIFIED
SERVICE TECHNICIAN,
FIGURE 4— MOTOR PART NO. 69183
SUPPLIED WITH MODEL 113.243311 ONLY
Key
No. Part
No.
Description
1 60306 Screw, 8-32 x 3/8, Thread
Cutting, Slotted, Serrated
Hd.
2 64088 Cover, Terminal
3 64258 Cord with Plug
TERMINAL
MOTOR CONNECTIONS
WARNING: FOR YOUR OWN SAFETY, NEVER
CONNECT PLUG TO POWER SOURCE OUTLET UNTIL
ALL ASSEMBLY STEPS ARE COMPLETED.
1. Open motor connector box cover located on left end of
motor (viewed from rear of saw) using a flat blade
sc rewdriver.
2. Remove GREEN SCREW and lockwasher and insert
screw through round metal terminal on the end of the
GREEN wire of power cord with lockwasher between
terminal and motor frame. (See illus.)
3. Reinsert GREEN SCREW in the threaded hole. Tighten
securely
4, Insert terminal end of WHITE wire on spade terminal
marked T4 on the motor. Push terminal firmly until
seated.
5, Insert terminal end of BLACK wire on spade terminal
marked T1 on the motor. Push terminal firmly until
seated.
6, Close motor connector box being sure that power cord is
seated in the largest strain relief groove, and tighten box
cover screws.
29