Sears 113.243311 - Manual (Page 7)

THE FOLLOWING PARTS'
fWODEL 113,243311 ONLY.
ARE INCLUDED WITH
Item Description Qty.
A 'Nut, Hex Head 1/2-13............................... 8
A * Nut Hex 1/4-20........................................ 32
B 'Screw Truss Hd. 1/4-20 x 5/8.................... 32
C * Lockwasher, 1/4 External ....................... 32
D * Foot, Leveling.......................................... 4
E Motor............ .......................................... 1
F 4
G Channe!, Support.................................... 2
H Stiffener, Side.......................................... 2
J Stiffener, End........................................... 2
K Support, Motor ........................................ 1
HARDWARE FOR MOUNTING TOOL & MOTOR
L 'Screw, Hex Hd. 5/16-1 8 x 1..................... 4
C ' Lockwasher Ext. 5/16............................... 8
A 'Nut, Hex 5/16-18....................................... 8
M ' Washer 11/32 ID ..................................... 8
N * Bolt, Carriage 5 / 1 6 - 1 8 x 3 / 4 ............... 4
Parts Contained In Loose Parts Bag Part No. 69097
M
assembly
ASSEMBLING STEEL LEGS
1. Assemble the two (2> End Stiffeners and the two (2)
Side Stiffeners using four (4) 1/4-20 Truss head screws.
The End Stiffeners are placed on top of each Side
Stiffener as shown. Insert screws through the 9/32 inch
diameter holes and attach lockwashers and 1/4-20 nuts
and finger tighten nuts.
2. Attach the four (41 legs to the Side and End Stiffeners
using 1/4-20 screws, lockwashers and nuts as shown.
3. Remove the tour (4) Truss head screws which were
assembled in Paragraph No. One. Place the two (2)
Support Channels as shown, in position, align holes in
supports with holes in the Stiffeners, replace lockwashers
and nuts. Tighten all nuts using 7/16" wrench.
4. Assemble the motor support to steel legs with 1/4-20
screws and nuts. Motor support can be mounted to
either end of stand. Tighten nuts.
5. install leveling feet as shown. To level Leg Set, Icxtsen
nut on inside of leg and turn nut on outside to raise or
lower feet. Adjust all four levelers, if necessary, and then
tighten nuts on inside of leg,
NOTE: These levelers are not intended for height ad­
justment.