Assembly – Sears 113.243311 User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
assembly
INSTALLING TABLE
Apply a coat of automobile wax to the table.
L Place the table on the band saw so that the two trunnion
pins and the table lock bolt go through the slot in the
trunnion,
2. Find the 1-1/8" dia- fiat washer, a sleeve 11/16" long,
the trunnion lock nut and the table lock handle from
among the loose parts.
3. Hold the head of the table lock bolt inside the band saw
with your left hand and put the 1-1/8'' dia. flat washer,
the sleeve, and the handle on the bolt,
4. Screw the nut on the bolt and tighten it with the handle
while the table is in a horizontal position.
“kJ
TABLE TRUNNION
TABLE LOCK BOLT TABLE LOCK HANDLE
BLADE TENSION
KNOB ^
INSTALLING THE BLADE
1. Find the blade tension knob among the loose parts. Put
a dab of grease or vaseline on the end of the knob and
screw it on the tension stud. Screw it on only a few
turns, just enough to start moving the pointer.
2. Loosen the two mounting screws and remove the blade
guard.
3, Loosen the guide bar lock screw and position the upper
guide assembly approximately three inches above the
table as shown and tighten the lock screw.
TENSION
STUD
POINTER
GUIDE BAR LOCK SCREW