Motor specifications and electrical requirements – Sears 113.244501 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
motor specifications and electrical requirements
This machine is designed to use, and is equipped with,
a 1725 RPfW motor It is wired for operation on 120
voits, 60 Hz., alternating current (TOOL MUST NOT
BE CONVERTED TO OPERATE ON 230 VOLT)
For replacement motor refer to parts list in this manual
CONNECTING TO POWER SUPPLY OUTLET
This machine must be grounded white in use to protect
the operator from electric shock.
Plug power cord into a 120V properly grounded type
outlet protected by a 15-amp fuse or circuit breaker.
If you are not sure that your outlet is properly grounded,
have it checked by a qualified electrician
WARNING; Do not permit fingers to touch the
terminals of plugs when installing or removing
the plug to or from the outlet.
WARNING: If not properly grounded this power
tool can cause an electrical shock, particularly
when used in damp locations close to plumbing.
If an electrical shock occurs there is the potential
of a secondary hazard such as your hands con
tacting the saw blade.
This plug requires a mating 3-conductor grounded type
outlet as shown,
!f the outlet you are planning to use for this power tool
is of the two prong type, DO NOT REMOVE OR
GROUNDING PRONG IN ANY MANNER
f
fclHBl t tmv I li if* Тиш, i f kiH,— Lf- i f lif^ • t Ч *hnA I f iXeffTt Ч \iii* P1 ^ • * I ^ « IV Ij Vi I VI* tmwl f'
) jcp on arianter яч shown below and alwavs cnnnent
V
m
/O w CiLI a
LVJf]
Oa
HE w W
l
the grounding lug to a known ground
it is recommended that you have a qualified electrician
replace the TWO prong outlet with a properly grounded
THREE prong outlet
QaOUNDING iUG
If power cord is worn or cut, or damaged in any way,
have it replaced Immediately,
Your unit is for use on 120 volts, and has a plug that
looks like the one shown below
This power tool is equipped with a 3-conductor cord
and grounding type plug approved by Underwriters’
Laboratories, The ground conductor has a green jacket
and IS attached to the tool housing at one end and to
the ground prong in the attachment plug at the other
end
An adapter as illustrated is available for connecting
plugs to 2-prong receptacles. The green grounding lug
extending from the adapter must be connected to a per
manent ground such as to a properly grounded outlet
box.
NOTE: The adapter illustrated is for use only if you
already have a properly grounded 2-prong receptacle.
NOTE: Make sure the proper extension cord is used
and is in good condition.
The use of any extension cord will cause some loss of
power. To keep this to a minimum and to prevent over
heating and motor burn-out, use the table below to
determine the minimum wire size (A.W.G.) extension
cord
Use only a single cord when an extension cord is
required. The cord must be a 3 wire extension cord
which has a 3-prong receptacle that will accept the
tools plug.
Length of the
Cord
Wire Sizes Required
(American Wire Gage Number)
120V Lines
25 Feet
No. 16
50 Feet
No. 16
too Feet
No. 16