Wilson Audio WATCH Dog Subwoofer Series-2 - Manual (Page 39)

39
Section 5.0 - WATCH Dog Setup
Preparation
You will need the following items:
• Supplied hardware kit
• Tape measure
• Known listening position
• Electric screwdriver
• Phillips head drive bit
Uncrating the WATCH Dog
A minimum of two strong adults are required to set up the WATCH Dog. The
WATCH Dog is very heavy and care should be taken to prevent injury.
1. With the crate lid facing up, unscrew the wood screws securing the lid.
Remove the lid. Remove the foam packing material that is positioned
between the casters (on the bottom of the WATCH Dog). The WATCH Dog
will not roll out of the crate with this packing material in place.
2. Rotate the crate so that the WATCH Dog is upright.
3. While one person holds the crate, another person should gently roll the
WATCH Dog out of the crate. Be careful not to scratch the sides of the
painted enclosure.
4. Move the WATCH Dog into the desired location. It is recommended that you
leave the casters attached to the bottom of the WATCH Dog during the
positioning process.
W AT C H D o g S e t u p