Viconics SED-DOR (ZigBee Pro) Installation Guide - Manual (Page 3)

SED-WIN/SED-DOR
Wireless Door/Window Switch 3
© 2
01
4 V
ic
on
ic
s T
ec
hn
ol
og
ie
s I
nc
. A
ll r
ig
ht
s r
es
er
ve
d.
Viconics Technologies Inc. | 9245 Langelier Blvd. | St.-Leonard | Quebec | Canada | H1P 3K9 | Tel: (514) 321-5660 | Fax: (514) 321-4150
028-0415-01 www.viconics.com | [email protected] November 2014
The SED-WIN & SED-DOR series ZigBee Pro™ wireless switches are
used with the wireless versions of VT8000/VT7000 Series Terminal
Equipment Controllers.
A typical hospitality application is where the VT8000 wall terminal equip-
ment controller has an on-board PIR sensor and wireless switches are
used to monitor the opening and closing of doors and windows.
Wireless door switches used with the local VT8000 PIR cover provide
advanced local occupancy routines allowing for increased energy sav-
ings during occupied hours without sacrificing occupant comfort.
Wireless window switches are used to monitor outside windows and or
patio and balcony doors being opened or closed. This allows prevention
of unnecessary energy consumption by the tenants.
Typical applications of VT8000/7000 Series Room Controllers with SED-
WIN & SED-DOR series Zigbee Pro™ wireless switches can be used in
network ready mode with or without integration to a central management
system to allow for advanced functions such as central reservation oc-
cupancy functions.
A combination of up to twenty SED-WIN & SED-DOR door and/or win-
dow switches can be used simultaneously with a single VT8000 Series
Terminal Equipment Controller.
The SED-WIN & SED-DOR switches are factory delivered with 2 AAA
batteries and can be installed, configured, and used right out of the
box. Due to extremely small current consumption of the switches, the
expected battery life is approximately 10 years and is equivalent to the
battery shelf-life.
No tools are required for commissioning or servicing the door switch. A
very simple interface with an on-board LED and hidden switch provides
the required functions for local interaction. Local information for battery
life and connectivity (heartbeat) are provided at the VT8000/7000 Series
Terminal Equipment Controller local display level, or through the Zigbee
Pro™ wireless network.
Each switch is also factory supplied with a magnet, locking security
tamper proof screw, and self tapping mounting screws for installation.
Model Chart
PART NUMBER DESCRIPTION
SED-WIN
SED-DOR
Wireless Window Switch (Patio and balcony
doors) Complete with magnet, batteries,
and required mounting hardware.
SED-WIN
SED-DOR
Wireless Door Switch
Complete with magnet, batteries,
and required mounting hardware.
To verify if the device is a wireless window switch or wireless door
switch:
Power cycle the switch (remove the battery for 60 seconds and then
insert again) and verify the LED blinking pattern to confirm if it is a
window switch or door switch; or simply read the label located on the
electronic board.
Part Number Number of Blinks
Window Switch (SED-WIN & SED-DOR) 2 blinks
Door Switch (SED-WIN & SED-DOR) 3 blinks
WARNING: Respect polarity when replacing batteries or the switch may
be damaged. The (+) and (–) terminals are indicated on the board.
NOTE: The magnet is located on opposite side of security screw.
(Opposite side of the batteries)
LED
(switch side)
Pull Tab
(remove to power
up switch)
Hidden
Switch
Figure-4 Wireless Switch Components
Figure-5 Magnet Components and Proper Magnet
Orientation
Housing
Magnet